CD18114M Mushroom Head Crimp Anchor (Box of 100pcs)

*For further description please see Simpson Strong-Tie Anchoring and Fastening Systems Catalog.

**Click Load Table icon for size & drill bit requirements.

---

CRIMP Multi-Purpose Anchors

The Crimp anchor is an easy-to-install expansion anchor for use in concrete and grout-filled block. The pre-formed curvature along the shaft creates an expansion mechanism that secures the anchor in place and eliminates the need for a secondary tightening procedure. This speeds up anchor installation and reduces the overall cost.

Four Crimp anchor head styles are available to handle different applications that include fastening wood or light-gauge steel, attaching concrete formwork, hanging overhead support for sprinkler pipes or suspended ceiling panels..

Warning: Industry studies show that hardened fasteners can experience performance problems in wet or corrosive environments. Accordingly, with the exception of the duplex anchor, use these products in dry, interior and non-corrosive environments only.

MATERIAL

Carbon steel

FINISH

Zinc plated and mechanically galvanized

CODE REPORTS

Factory Mutual 3031136 for the 3/8" Rod Coupler.

HEAD STYLES

Mushroom, rod coupler, tie-wire and duplex

INSTALLATION

Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 1/2" deeper than the required embedment.

Blow the hole clean of dust and debris using compressed air. Overhead application need not to be blown clean. Where a fixture is used, drive the anchor through the fixture into the hole until the head sits flush against the fixture.

Be sure the anchor is driven to the required embedment depth. The Rod Coupler and Tie-Wire models should be driven in until the head is seated against the surface of the base material.