DIA75 Drop-In Anchor (Carton of 80pcs)

*For further description please see Simpson Strong-Tie Anchoring and Fastening Systems Catalog.

**Click Load Table icon for size, drill bit dia.(in.), wrench (in.) and box/carton quantities.

---

DROP-IN Internally-Threaded Expansion Shell Anchor

DROP-IN Internally-Threaded Expansion Shell Anchor Information on this page has been updated since the printing of the 2009-2010 Anchor Systems Catalog. To view the specific changes made to this page in detail, see Catalog Changes and Corrections. Drop-in anchors are internally-threaded, deformation-controlled expansion anchors with a preassembled expander plug, suitable for flush mount applications in solid base materials. The anchor is set by driving the expansion plug towards the bottom of the anchor using the setting tool. Drop-in anchors are also available in coil-threaded versions for 1/2" and 3/4" coil threaded rod.

The Lipped Drop-In (DIAL) features a lip at the top of the anchor body that keeps the top of the anchor flush with the concrete. This eliminates the need for precisely drilled hole depths and allows for easier flush installation, consistent embedment and uniform rod lengths.

The Short Drop-In Anchor (DIAS) is for use in solid and hollow concrete. The short length enables shallow embedment that helps avoid drilling into rebar or prestressed or post-tensioned cables. The wide surface flange allows the DIAS to be installed in deep or bottomless holes.

MATERIAL Carbon and stainless steel (DIAS available in zinc plated carbon steel only)

FINISH Carbon steel: Zinc plated.

INSTALLATION For installation instructions, click here.

CODE REPORTS Drop-In: �¡Factory Mutual 3017082 �¡Underwriters Laboratories File Ex3605 �¡Meets requirements of Federal Specifications A-A-55614, Type I. Short Drop-In: �¡Factory Mutual 3017082 & Underwriters Laboratories File Ex3605. (DIA37S only) The load tables list values based upon results from the most recent testing and may not reflect those in current code reports. Where code jurisdictions apply, consult the current reports for applicable load values.

TEST CRITERIA The Drop-In anchor has been tested in accordance with ICC-ES's Acceptance Criteria for Expansion Anchors (AC01) for the following:

�¡Seismic/wind loading �¡Combination tension and shear loads �¡Critical and minimum edge distance and spacing SUGGESTED SPECIFICATIONS Drop-In anchors shall be internally threaded, expanding shell anchors. The anchor shell shall be zinc plated carbon steel with a minimum 70,000 psi tensile strength, type 303 or 316 stainless steel, as called for on the drawings. Drop-In anchors shall meet Federal Specification A-A-55614, Type I. Anchors shall be Drop-In anchors from Simpson Strong-Tie, Pleasanton, CA. Anchors shall be installed following the Simpson Strong-Tie instructions for Drop-In internally threaded expansion shell anchors.