EZAC50600 Easy-Set Pin Drive Expansion Anchor (Carton of 100pcs)

*For further description please see Simpson Strong-Tie Anchoring and Fastening Systems Catalog.

**Click Load Table icon for size, drill bit dia.(in.), wrench (in.) and box/carton quantities.

---

EASY-SET Pin Drive Expansion Anchor

The Easy-Set is a pin drive expansion anchor for medium and heavy duty fastening applications into concrete and grout-filled block. Integrated nut and washer helps keep track of parts.

MATERIAL

Anchor body – Hot-rolled steel; Pin – Hot-wrought carbon steel.

FINISH

Yellow zinc dichromate coating

INSTALLATION

Note: Hole in fixture to be mounted must be at least 1/16" greater than the anchor diameter.

Caution: Oversized holes in the base material will make it difficult to set the anchor and will reduce the anchor's load capacity.

•Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. Drill the hole to the specified embedment depth plus 1/4" to allow for pin extension and blow it clean using compressed air. Overhead installations need not be blown clean. Alternatively, drill the hole deep enough to accommodate embedment depth and dust from drilling.

•Adjust the nut for required embedment. Place the anchor through the fixture and into the hole.

•Hammer the center pin until the bottom of the head is flush with top of anchor.