*FREE Ground Shipping over $199.00 *Exclusions Apply*

JB210A Top Flange Joist Hanger (Carton of 25pcs) Ostock

Simpson Strong-Tie

Write a Review
Retail Price: $245.25
Sale Price: $159.50
SKU:
jb210a-c25-g90-ostock
UPC:
707392170471
Availability:
Usually ships the same business day
Finish:
G90 Galvanized

Product Overview

JB210A Top Flange Joist Hanger (Carton of 25pcs)

The LBAZ and JBA hangers provide higher loads for 2x10, 2x12 and 2x14 members in 14-gauge and 18-gauge steel, respectively. The nail locations on the JBA enable effective use with nailers.

The BA hangers are cost-effective hangers featuring min./max. joist-nailing options. Min. Nailing featuring Positive Angle Nailing targets moderate load conditions whereas the Max. Nailing generates capacities for higher loads. The unique two-level embossment provides added stiffness to the top flange. See tables. See Hanger Options for hanger modifications, which may result in reduced loads.

Material:

JB/JBA — 18 gauge; LB/LBAZ — 14 gauge; BA — 14 gauge or 12 gauge; HB — 10 gauge

For modified hangers, gauge may increase from that specified for non-modified hangers. Hanger configurations, height and fastener quantity may increase from the tables depending on joist size, skew and slope. Embossments may be omitted.

Finish:

Galvanized (G90)

Installation:

Use specified fasteners; see General Notes and nailer table notes.

B, LBAZ and BA may also be welded to steel headers with weld size to match material thickness. The minimum required weld to the top flanges is 2" (1 7/16" for LBAZ) fillet weld to each side of each top flange tab. Distribute the weld equally on both top flanges. Welding cancels the top and face nailing requirements. Consult the code for special considerations when welding galvanized steel. The area should be well-ventilated (see General Instructions for the Installer, note k for welding information). Weld on applications produce the maximum allowable download listed. For uplift loads refer to technical bulletin Top-Flange Hangers Welded to Structural Steel Members (T-C-WELDUPLFT).

Ledgers must be evaluated for each application separately. Check TF dimension, nail length and nail location on ledger.

For modified hangers, fastener quantity may increase from the tables depending on joist size, skew and slope.

Bevel cut the carried member for skewed applications.

Options:

See modification tables for allowed options and associated load reductions