Product Overview
RWH25100 Wood Rod Hanger (Box of 25pcs)
The wood rod hanger from Simpson Strong-Tie is a one-piece fastening system for suspending 1/4" or 3/8" threaded rod. Vertical rod hangers are designed to suspend threaded rod in overhead applications from wood members. Horizontal rod hangers are available for applications requiring installation into the side of joists, columns and overhead members. Both rod hangers provide attachment points for use in pipe hanging, fire protection, electrical conduit and cable-tray applications. Recommended for use in dry, interior, non-corrosive environments only.
Key Features:
Threaded anchors for rod-hanging applications in wood
Suitable for installation horizontally or vertically in overhead applications
No predrilling required
Easily installed with a drill or screw gun
Type-17 tip provides for fast starts
UL/FM Listed
Material:
Carbon steel
Finish:
Zinc plated
Installation:
Installation Sequence
Attach RND62 nut driver to a drill.
Insert rod hanger into the RND62 nut driver.
Using rotation-only mode, drive rod hanger until it contacts the surface. Do not over-tighten. RND62 nut driver will disengage the rod hanger at the appropriate depth to prevent over-driving.
Insert threaded rod. Minimum thread engagement should be equal to the nominal diameter of the threaded insert.
The wood rod hanger from Simpson Strong-Tie is a one-piece fastening system for suspending 1/4" or 3/8" threaded rod. Vertical rod hangers are designed to suspend threaded rod in overhead applications from wood members. Horizontal rod hangers are available for applications requiring installation into the side of joists, columns and overhead members. Both rod hangers provide attachment points for use in pipe hanging, fire protection, electrical conduit and cable-tray applications. Recommended for use in dry, interior, non-corrosive environments only.
Key Features:
Threaded anchors for rod-hanging applications in wood
Suitable for installation horizontally or vertically in overhead applications
No predrilling required
Easily installed with a drill or screw gun
Type-17 tip provides for fast starts
UL/FM Listed
Material:
Carbon steel
Finish:
Zinc plated
Installation:
Installation Sequence
Attach RND62 nut driver to a drill.
Insert rod hanger into the RND62 nut driver.
Using rotation-only mode, drive rod hanger until it contacts the surface. Do not over-tighten. RND62 nut driver will disengage the rod hanger at the appropriate depth to prevent over-driving.
Insert threaded rod. Minimum thread engagement should be equal to the nominal diameter of the threaded insert.
