ETB160A-SCRB Hidden Tiber Connector Kit

ETB160A-SCRB Hidden Tiber Connector Kit

The ETB hidden connector provides a load-tested beam connection without any visible hardware. Interlocking plates are fastened onto each member and lock together for a secure structural connection.

Key Features

Faster than other time-consuming methods and requires removal of less beam material

Three sizes address common beam sizes from 4x6 through 6x12

Connector can be routed into the beam end for a completely flush installation

Templates available to make accurate installation more efficient

Material

Plates — Aluminum 6082-T6

Finish

Plates — none; screws — Dacromet® corrosion-resistant coating

Installation

Use all specified fasteners; see General Notes.

Rout a 3/8" (10mm) deep pocket into the side of the supporting beam as shown for the lower plate.

Install lower plate with 16d hot-dip galvanized nails (not included in kit).

Install horseshoe plate onto end of supported beam using SCRB screws supplied in kit. Screws are installed at a downward angle (approx. 45°).