PRODUCT DESCRIPTION - Click to Enlarge Inset Picture
HWPH7.12/18 High-Wind Purlin Heavy Hanger
The HWPH is designed to support joists on purlins or beams in both wood and cold-formed steel construction. This heavy top-flange hanger has enhanced uplift and is ideal for high-wind applications. The HWPH offers design flexibility and versatility that provides very high uplifts and down loads.
Modifiable with alteration options including opened/closed top-flange and offset top-flange
Top flange may be sloped to a maximum of 35° to accommodate a sloped header
Features a solid one-piece top flange that provides extra stability in panelized roof applications
Available with a sloped and/or skewed seat up to 45°
3-gauge top flange and 7-gauge stirrup
Simpson Strong-Tie gray paint. Hot-dip galvanized available; specify HDG.
Use all specified fasteners.
The HWPH may be used for weld-on applications. The minimum-size weld is a 1 1/2"-long fillet weld to each side of the top flange; weld size to match hanger material thickness. See General Instructions for the Installer, note k for weld information. Weld-on applications have the maximum allowable capacity listed. Uplift loads do not apply to this application.
Non-modified hangers can support joists sloped up to 1.4 :12 using table loads. For joists sloping between 1/4 :12 and 3/4 :12 use 85% of the table loads. See technical bulletin Sloped Joist in Non-Sloped Hangers (T-C-SLOPEJST).
Web stiffeners are required for these hangers.
If joist is shorter than hanger by more than 1/2" use only 50% of the table loads.